SG5100ex (Ex II 1G Ex ia IIB T3 Ga) sampler without charger

SG5100ex (Ex II 1G Ex ia IIB T3 Ga) sampler without charger

SKU: 00144
Category: SG5100ex

Sampling device SG5100ex (II 1G Ex ia IIB T3 Ga) for personal and stationary sampling of hazardous substances at the workplace (dusts, fibers, gases, vapors, molds in the work area) up to 4,000 ml/min without charger. The standard working range is 0°C to 40°C.

1.769,00 €

excl. 19% VAT , plus (Versicherter Versand)

Delivery time: 33 - 42 Workdays (Other countries)

pcs

Description
Question about item

The air sampler SG5100ex has been developed for the movable and stationary sampling of gaseous and particulate matter, especially in explosive atmosphere until 4,000 ml/min.

The air sampler SG5100ex is developed especially for explosive atmospheres.

It is equipped with a powerful rotary vane pump, which generates a nearly pulsation-free vacuum and can overcome high flow resistances. The sampler is easy to operate and covers a wide adjustable flow range from approx. 50 to 4,000 ml/min without any gap.
The requirements on a constant volume flow with changing flow resistance with fault indication and automatic shut-off are fulfilled through the automatic volume flow regulation over the complete range.
As the successor of the SG4000ex has the SG5100ex a larger flow rate and by its changeable batterys is it easy to use. For a very short sampling time of maximum 2 hours, it is technically possible to perform the sampling with the sampling device in the extended temperature range of -5°C to 50°C. This can lead to an overload of the device, so that in case of a damage of the device no warranty is taken over.

Please notice: This sampler will be delivered without the power supply!

Specifications:

Nominal flow rate: 50-4000 ml/min (± 5 %)
electronic flow regulation
Adjustable flow rate: approx. 20-5,000 ml/min
Lithium-Ion battery 2,4 Ah, 17,76 Wh, 7,4 V
Battery is easy to change
Sampling time programmable, automatic switching-off, battery-buffered data storage
Display shows actual capacity of the battery, running time of errors
Electronical adjusting
Run time: approx. 8h
Charging time: approx. 8h (automatic switching to trickle charge)
LCD-Display, 2x8 digits
Dimensions (WxDxH): 87x40x101mm
Weight: 540 g

For the personal measurement of noxious substances in the air at work places small, light-weight, battery-powered pumps (PAS) are used, which are connected to appropriate sampling systems for the collection of the pollutants. The system is worn by persons in whose breathing zone the concentration of hazardous substances is to be determined. For the sampling of dust, fibers and also mould fungus the combination filter head system PGP (license IFA) is utilized, for gas sampling tube holders with sorption tubes are used.

Construction and Operation:
The air sampler SG5100ex is equipped with a rotary vane pump which generates together with the buffer volume a nearly pulsation-free vacuum. The desired flow rate is adjustable from approx. 50 up to 4,000 ml/min. The adjusted volume flow will be kept automatically constant during the sampling time by means of the integrated flow regulation. This regulation compensates the usual decrease of the volume flow as consequence of the increasing flow resistance (e.g. filter loading) or descending battery voltage.
The sampling parameters are programmable and readable on the 2x8-digit display. The sampler switches off automatically reaching the preset sampling time or, after a certain time of fault indication on the display, when the adjusted flow rate cannot be kept constant inside the required tolerance range because of too high flow resistance or too low battery voltage. The run time until the switching-off is stored, accordingly the duration of sampling can be read at a later time. The complete program flow and regulation are controlled by a built-in microprocessor. The SG5100ex is provided with an internal battery management to ensure a controlled charging of the integrated Lithium-Ion-battery and to indicate the approximate charging time and charging status of the battery in %. The keys can be locked.
There are separate batteries available; therefore a change by you is possible.
Please use only our battery for exchange. Only this guarantees the protection in explosive atmospheres!

Scope of supply:

Sampler SG5100ex
upon request User instruction (German/English) and Quick Start Guide (German/English)

Available accessories:

Charger SG2500-2/5100/5200
Transport cases (on request)
Different float flow meters
Different collection heads for hazardous substances
Tube support
Replacement battery for independent exchange

Of course you will find further equipment at our online store. If you have any questions, please use our contact form or just call us.

Shipping information:

No dangerous good of class 9
Classification UN3481
Transport ADR (street): no marking necessary
Transport IATA (air traffic):

o 1-2 implement/package: no marking
o 3 or more implements/package: marking necessary according to UN3481 – PI967, for further information please click here

Usage:

Operating range:	Stationary Personal Sampler
E-dust fraction:	particularly suitable
Ex-Protection:	Ex-protection II 1G EEx ia IIB T3
fibre measurement according to DGUV 213-546 raster electronical method:	particularly suitable
fibre measurement according to DGUV 213-531 light microscopy method:	particularly suitable
Welding fume:	particularly suitable
change of battery unit possible:	yes
Volume flow:	50 - 4,000 ml/min
A-dust fraction:	suitable
Gases (VOC, formaldehyde, etc.):	suitable
Fibre measurement according to VDI 3492 (e.g. asbestos, MMMF, glas fibre):	not suitable
PAK / PCB according to VDI 2463 p. 7:	not suitable
Item weight:	0,55 kg

Contact data

Title

First name

Last name

Company

E-Mail

Phone

Mobile phone - optional

Fax - optional

Question about item

Your question